However, you will also be unable to add any standard I/O modules to your project or have I/O addressed in your code and therefore you may also have to discuss this issue further with Rockwell to see if there is a better option in place. It has been shown that with one or more Ethernet-based drivers installed, requests return with CIP Error 0x5 Ext. NOTE: No Other Ethernet Drivers in RSLinx - For proper operation, no Ethernet-based drivers (Ethernet Devices, Remote Devices Via Gateway, etc) should be installed in RSLinx on the SoftLogix PC. The Device ID should be set to ', 1, '.įor example, if the PC's IP address is 192.168.3.4 and the SoftLogix CPU is in slot 2 of the virtual chassis, then the correct Device ID would be '192.168.3.4, 1, 2'. In the General tab, locate the Device ID value. There are two components to any OPC DA alarm, the data on which the alarm is based. Save the Source and click the Alarms link in the navigation menu to create an OPC DA alarm. Redundant OPC DA is outside the scope of this document. Leave the radio button set to Single Source. Verify that the Ethernet/IP Message Module is installed in the SoftLogix virtual chassis. The server name is the name of your actual OPC DA server. To connect the Allen-Bradley ControlLogix Ethernet Driver to a SoftLogix Soft PLC running on the same PC as the server, follow the instructions below.Įnsure that there are no Ethernet-based drivers currently running in RSLinx on the PC. Error 0x1 and CIP Error 0x8.Ĭonnecting to a SoftLogix Soft PLC on the Same PC as the OPC Server With one or more Ethernet-based drivers installed, requests will return with CIP Error 0x5 Ext. Pasted below are the Softlogix operating notes.įor proper operation, no Ethernet-based drivers (such as ethernet devices, remote devices via Gateway, and so forth) should be installed in RSLinx on the SoftLogix PC. This is not a good option as it does not use the ControlLogix or SoftLogix driver.Ĭonsider using the SoftLogix driver instead This needs IGS to be set to Interactive mode and therefore cannot run as a service. The only way to connect with Rslogix Emulate 5000 to IGS is via a DDE client connection which means using the DDE client driver. RsLogix Emulator with the IGS driver needs a DDE client connection Request documentation on setting up the RsLogix Emulator with the IGS driver

Rslinx opc server setup